803
Calling Party Number Presentation for either ISDN – BRI or PRI:
ETU Setup (PRTA PKG Setup) – CLIP
Information
Based on this setting, the system includes
Presentation Allowed (1) or Presentation
Restricted (0) in the Setup message to allow or
deny the Calling Party Number. Program
15-01-04 must also be set to 1 if this option is
enabled.
Basic Extension Data Setup – ISDN Caller ID
If Program 15-01-04 and Program 10-03-05 are
enabled, the system includes Caller ID in the
Setup message as Presentation Allowed. If
these options are disabled, it is Presentation
Restricted.
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Outgoing Call
Service) – ISDN CLIP
Determine if the ISDN calling line identity
presentation and screening indicators should
be allowed.
ISDN Calling Party Number Setup for Trunks
Assign Calling Party Numbers for each trunk
(maximum 16 digits per entry). When a call is
made by an extension which does not have an
Extension Calling Number assigned (Program
21-13), the system sends the calling number for
the ISDN trunk defined in 21-12. If the Calling
Party Number is assigned in both Program
21-12 and Program 21-13, the system sends
the data in Program 21-13.
Maximum of 16 characters
(1 ~ 0, *, #)
ISDN Calling Party Number Setup for
Extensions
Assign a Calling Party Number (maximum 16
digits per entry) to each extension. The calling
number is the subscriber number of the dial-in
number. When a call is made by an extension
which does not have an Extension Calling
Number assigned (Program 21-12), the system
sends the calling number for the ISDN trunk
defined in Program 21-13. If a Calling Party
Number is assigned in both Program 21-12 and
Program 21-13, the system sends the data in
Program 21-13.
Maximum of 16 characters
(0 ~ 9, *, #)
To Next Page
Loading...
