NEC Univerge SV9100 - Automatic Trunk-To-Trunk Transfer (Step Transfer); Department Group Line Forwarding

169
Automatic Trunk-to-Trunk Transfer (Step Transfer) (follows the predefined destination in
Program 24-04-01) Set Automatic Trunk Forwarding:
The Speed Dial bin must be defined in Program 13-04-01 for the line to forward.
1. Lift the handset.
2. Dial 833.
3. Dial trunk port number to be used (001~400).
4. Press Speaker to hang up.
Cancel Automatic Trunk Forwarding:
1. Lift the handset.
2. Dial 834.
3. Dial trunk port number to be used (001~400).
4. Press Speaker to hang up.
Department Group Line Forwarding
Method 1:
Set the Destination and Forward the Line:
1. Lift the handset.
2. Dial 704.
3. Dial the Department Group number (01~64) to be defined.
4. Select the time mode (1~8) to be defined.
5. Enter the telephone number, which is the destination of the forwarded trunk.
 The number is stored in the Speed Dial bin number assigned in Program 24-04-01. This entry
overwrites any existing number defined in the bin.
6. Press Hold to accept the entry.
7. Repeat from Step 3 to define another time mode entry or press Speaker to hang up.
Cancel the Line Forwarding:
1. Lift the handset.
2. Dial 704.
3. Dial the Department Group number (01~64) to be defined.
4. Select the time mode (1~8) to be defined.
5. Press the Exit key.
6. Press Speaker to hang up.