NEC Univerge SV9100 - To Enter a Forced Account Code at a Single Line Telephone

24
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
 If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected
trunk.
2. Dial * .
3. Enter the Account Code (1~16 digits).
 You can enter any code of the proper length.
4. Dial * .
To enter a Forced Account Code at a single line telephone:
1. Access trunk for outside call.
 Dial a code to access a trunk.
 With Forced Account Codes, you hear, “Please enter an Account Code.”(depending on
programming).
2. Dial * .
3. Enter Account Code (3~16 digits).
4. Dial * .
5. Dial number you want to call.