NEC Univerge SV9100 - Resident System Program

1014
Resident System Program
Description
When power is supplied to the system, the hardware configuration is scanned and Resident System
Program default values are assigned including terminal types (e.g. PGD(2)-U10 ADP, DSS Console).
This enables immediate operation, even before the system is programmed to accommodate the
individual site requirements.
Conditions
Default assignments for multiline terminals are: LK 01~LK 08 corresponds to
CO 01~CO 08.
DSS Console to Extension assignments for Attendant Add-On Consoles are not assigned.
Default Attendant Add-On Console key assignments are:
DSS Keys = 001~060
Stations = 101~160
First Initialization of the system returns all programming values to default. Without a
PC-ATA USB Drive installed, press and hold the SW1 (Load Switch) and toggle the Reset
(SW2) switch. Continue to hold the SW1 switch for approximately 5~10 seconds before
releasing. The system boots loading Resident System Programming.
Default Settings
None
System Availability
Terminals
None
Required Component(s)
None