288
Cordless DECT Terminals
Description
The Cordless DECT Terminals may be used with the UNIVERGE SV9100 KTS. The DTL-8R-1 TEL
uses DECT Technology and is connected in tandem to a multiline terminal.
Refer to specific DECT Owner’s Manual for more information on the DTL-8R-1 terminal.
Press the applicable key on the Base Unit to Switch between Cordless operation and multiline terminal
operation.
2-line, 24-digit LCD Display
TALK, TRANSFER, HOLD, CONF, SPEAKER, REDIAL, MUTE, R/VOL
50~150 feet (expandable with repeaters)
Message Waiting Indication
5 channels by 12 time slots
* Determined by environmental conditions. These are cordless RF devices and, therefore, some interference may
take place when operating in the same environment as other wireless devices which operate within the same
frequency spectrum.
Conditions
If using the Base Switching option, Cordless DECT Terminal programmable keys:
1~4 can be set as a Programmable Function key such as Trunk Line Keys
5 and 6 can be set as One-Touch keys
7 and 8 are reserved for Base Switching and cannot be programmed
If the Base Switching option is not used, programmable keys 1~8 can be programmed as
Programmable Function Keys such as Trunk Line Keys.
The DTL-8R-1 Cordless DECT Terminals can be used in conjunction with the UNIVERGE
SV9100 and DT400/DT300 Digital Multiline Telephones.
Battery Capacity is 910 mAh, 2.4V with a Talk Mode of 16 hours (typical) and a Standby
Mode of seven days (typical).
The battery can be hot swapped while on a call. The battery must be replaced with another
charged battery pack within 20 seconds, otherwise the connection is lost.
The handset has visual and audible indicators to warn of a low battery condition.
To Next Page
Loading...
