377
System Options for Incoming Calls – DIL No
Answer Recall Time
A DIL that rings its programmed destination
longer than this time diverts to the DIL No
Answer Ring Group (set in Program 22-08).
Incoming Call Trunk Setup
Assign each DIL Service Type 4. Make an entry
for each Night Service mode.
Trunks 1 ~ 400
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
Incoming Extension Ring Group
Assignment
Assign the extensions that should receive the
overflow to the ring group programmed in
Program 22-08. Set the ringing in Program
22-06.
Extensions 101
~ 108 (first eight
ports) ring for
incoming Ring
Group 1 calls.
No other
extensions ring
for incoming
Ring Group 1
calls.
DIL Assignment
Set the destination extension number for each
DIL – for each Night Service mode. The
destination can be an extension port, virtual
extension number, or Department Group pilot
number (as assigned in Program 11-07-01).
For this selection to work, set Program
22-02-01 to 4 (DIL).
Day/Night Modes (1 ~ 8):
Extension Number (maximum of
eight digits)
Pilot Number
DIL/IRG No Answer Destination
For each DIL with delayed ringing, enter the DIL
No Answer Ring Group. An unanswered DIL
rings this group after the DIL No Answer Time.
Make an entry for each Night Service mode.
0 = (No Setting)
001 ~ 100 = Incoming Ring
Group
102 = (In-Skin/
External Voice Mail
or InMail)
103 = Centralized VM
Operation
To answer a call on your Direct Inward Line:
1.
Lift the handset.
2.
Press the flashing line key for DIL on the multiline terminal.
Press the flashing Answer Key to put the first call on hold and answer the second incoming
call. This can be repeated until all incoming calls are answered.
If you have Ringing Line Preference, lift the handset to answer the call.
If you do not answer the call, it may ring other extensions (i.e., the DIL No Answer Ring
To Next Page
Loading...
