NEC Univerge SV9100 - To Change Your Extension Incoming Ring Tones

1068
Program
Number
Program Name/Description
Input Data
Default
15-10-01
Incoming Virtual Extension Ring Tone Order
Setup
When two or more virtual extensions are set on
a function key on the telephone, and the tone
pattern by which the sound of each extension
differs, the priority of ring sound is set up.
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Extension Ring
Tone
5 = Tone Pattern 5
6 = Tone Pattern 6
7 = Tone Pattern 7
8 = Tone Pattern 8
Priority order:
1 = 0 (Tone
Pattern 1)
2 = 1 (Tone
Pattern 2)
3 = 2 (Tone
Pattern 3)
4 = 3 (Tone
Pattern 4)
22-03-01
Trunk Ring Tone Range
Select the ring tone range for the trunk. The
trunk uses a ring tone in the range selected
when it rings an extension. Eight ring tones are
available.
0 ~ 12
(Ring Tone Pattern 1 ~ 4)
(Melody 1 ~ Melody 5)
(Ring Tone Pattern 5 ~ 8)
0
Intercom or Trunk Ring Setting
1 = High
5 = Ring Tone 2
2 = Mid Range
6 = Ring Tone 3
3 = Low
7 = Ring Tone 4
4 = Ring Tone 1
8 = Ring Tone 5
Operation
To change your extension incoming ring tones:
1. Press Speaker.
2. Dial 820.
3. Dial 1 to set Intercom ring; 2 to set trunk ring.
4. Dial code for the desired ring pattern (1~8).
5. Press Speaker to hang up.
To listen to the incoming ring choices:
1. Press idle Speaker.
2. Dial 811.
3. Dial 1 to listen to Intercom ring; 2 to listen to trunk ring.
4. For Intercom Ring:
Dial the code for the ring pattern you want to hear (1~8).
- OR -