NEC Univerge SV9100 - Assign Trunks as Automated Attendant Trunks - Method 1

587
Program
Number
Program Name/Description
Input Data
Default
22-08-01
DIL/IRG No Answer Destination
Assign the DIL No Answer Ring Group.
0 (No Setting)
001 ~ 100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or InMail)
103 = Centralized VM
1
24-02-02
System Options for Transfer – MOH or
Ringback on Transferred Calls
Enable/Disable MOH on Transfer. If set to 0, a
transferred caller hears Music on Hold while
their call rings the destination extension. If set
to 1, a transferred caller hears ringback while
their call rings the destination extension. For
this option to work with voice mail, the
transferred call must be an unscreened
transfer.
0 = Hold Tone
1 = Ring Back Tone
0
Assign Trunks As Automated Attendant Trunks – Method 1:
Program
Number
Program Name/Description
Input Data
Default
22-02-01
Incoming Call Trunk Setup
Assign Service Type 4 to each trunk you want
to ring into Voice Mail as a Direct Inward Line
(DIL).
Trunks 1 ~ 400
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0
22-07-01
DIL Assignment
Assign the master/pilot number of the voice
mail group from Program 11-07-01 as the DIL
destination. If all Voice Mail ports are in the
same unique Extension (Department) Group
(see Program 16-02 above), the DIL rings
another Voice Mail port if its assigned port is
busy.
For this selection to work, set Program 22-02-01 to
4 (DIL).
Day/Night Modes (1 ~ 8):
Extension Number (maximum of
eight digits)
Pilot Number
No Setting