NEC Univerge SV9100 - Tandem Trunking to Speed Dial Number

1204
Program
Number
Program Name/Description
Input Data
Default
24-02-10
System Options for Transfer – Disconnect
Trunk-to-Trunk
This timer starts after the Trunk-to-Trunk
warning tone is heard.
0 ~ 64800 seconds
0
25-07-07
System Timers for VRS/DISA – Long
Conversation Warning Tone Time
Determine the time a DISA caller or any
trunk-to-trunk (such as Tandem Trunking)
conversation can talk before the Long
Conversation tone is heard.
0 ~ 64800 seconds
3600
25-07-08
System Timers for VRS/DISA – Long
Conversation Disconnect Time
Determine the time the system waits before
disconnecting a DISA or any trunk-to-trunk
(such as Tandem Trunking) conversation call
after the Long Conversation tone is heard.
0 ~ 64800 seconds
10
Method D – Tandem Trunking to Speed Dial Number:
Program
Number
Program Name/Description
Input Data
Default
11-10-06
Service Code Setup (for System
Administrator) – Setting the Automatic
Transfer for Each Trunk Line
If the default service code (733) for enabling
Automatic Tandem Trunking feature is not
acceptable, change the code as required.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
833
11-10-07
Service Code Setup (for System
Administrator) – Canceling the Automatic
Transfer for Each Trunk Line
If the default service code (734) for canceling
Automatic Tandem Trunking feature is not
acceptable, change the code as required.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
834
11-10-08
Service Code Setup (for System
Administrator) – Setting the Destination for
Automatic Trunk Transfer
If the default service code (735) for setting the
destination of the Automatic Tandem Trunking
feature is not acceptable, change the code as
required.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
835
13-04-01
Speed Dialing Number and Name – Speed
Dialing Data
Enter the number and name for the bins used to
hold the Automatic Tandem Trunking
destination.
Maximum of 24 digits.
(1 ~ 9, 0, *, #
Pause (Press line key 1)
Recall/Flash (Press line key 2)
@ = Code to wait for answer
supervision in ISDN (Press line
key 3)
No Setting
13-04-02
Speed Dialing Number and Name – Name
Assign a name to each System Speed Dial bin.
Maximum of 12 characters
(Use dial pad to enter name).
No Setting
13-04-03
Speed Dialing Number and Name – Transfer
Mode
Assign the transfer mode for each System
Speed Dial bin.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring Group (IRG)
0