NEC Univerge SV9100 - To Record a VRS Message

1351
Program
Number
Program Name/Description
Input Data
Default
40-10-05
Voice Announcement Service Option – Park
and Page Repeat Timer (VRS Msg Resend)
If a Park and Page is not picked up during this
time, the Paging announcement repeats.
0 ~ 64800 seconds
0
40-10-06
Voice Announcement Service Option – Set
VRS Message for Private Call Refuse (VRS
Msg Private Call)
Assign the VRS Message number used as
Private Call Refuse. When Fixed message is
set, VRS message guidance is: Service
finished. Disconnect the line, please.
0 ~ 101
(0 = No message) (101
= Fixed message)
0
40-10-07
Voice Announcement Service Option – Set
VRS Message for Caller ID Refuse (VRS Msg
CID)
Assign the VRS Message number used as
Caller ID Refuse. When Fixed Message is set,
VRS message guidance is: Service finished.
Disconnect the line, please.
0 ~ 101
(0 = No message) (101
= Fixed message)
0
40-11-01
Preamble Message Assignment
Assign the VRS Message number used as the
Preamble Message for each trunk. When the
extension user answers the incoming call, the
assigned VRS message is sent to the outside
caller.
0 ~ 100
(0 = No Service)
0
47-03-02
SV9100 InMail Group Mailbox Options –
Mailbox Number
The Group Mailbox Number is the same as the
Department Group master (pilot) number.
Select the Department Group master (pilot)
number associated with the Master Mailbox you
are programming.
Digits (eight maximum, using
0 ~ 9)
No Setting
(entered by pressing Hold)
No Setting
Operation
VRS Messages
To record a VRS message:
1. Press Speaker or lift the handset.
- OR -
At a single line telephone, lift the handset.
2. Dial 716.
3. Dial 7 (Record).
4. Dial the VRS message number you want to record (01~100).