NEC Univerge SV9100 - To Redial a Saved Number; To Save the Outside Number You Just Dialed

1034
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-12-13
Service Code Setup (for Service Access) –
Saved Number Dial
Customize the service code used for dialing a
saved number.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
815
11-12-18
Service Code Setup (for Service Access) –
Clear Saved Number Dialing Data
Define the service code for Clear Save Number
Dialing List if it is not acceptable.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
885
15-07-01
Programmable Function Keys
Assign a function key as a Save key (code 30).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
Operation
To save the outside number you just dialed (up to 24 digits):
Use this feature before hanging up.
Multiline Terminal
1. Press the Save Number Dialed key (Program 15-07 or SC 851: 30).
Single Line Telephone
1. Hookflash.
2. Dial 815.
To redial a saved number:
Multiline Terminal
1. Press an idle trunk line key.
 This selects a specific trunk for the call.
2. Press the Save Number Dialed key (Program 15-07 or SC 851: 30).
 The stored number dials out.
- OR -
1. Press Speaker.
2. Dial 815.
- OR -