NEC Univerge SV9100 - Transferring Calls to a Mailbox

610
access codes:
848 = Call Forward – Immediate (Program 15-07 or SC 851: code 10)
843 = Call Forward – Busy (Program 15-07 or SC 851: code 11)
845 = Call Forward – No Answer (Program 15-07 or SC 851: code 12)
844 = Call Forward – Busy/No Answer (Program 15-07 or SC 851: code 13)
2. Dial the Voice Mail master number.
3. Press Speaker to hang up (or hang up handset at the single line telephone).
Transferring Calls to a Mailbox
To transfer your active call to a mailbox:
Multiline Terminal
1. Press Hold.
2. Press the Voice Mail key (Program 15-07 or SC 851: code 77 + InMail pilot).
- OR -
Press the Message key on the telephone, if equipped.
3. Dial the number of mailbox to receive the transfer.
 This number can be a mailbox number or a co-worker’s mailbox number.
- OR -
Press the DSS Console or One-Touch key for extension user’s mailbox, which receives the
transfer.
 If the Transfer destination is an extension forwarded to Voice Mail, the call waits before routing the
called user’s mailbox. This gives you the option of retrieving the call instead of having it picked up by
Voice Mail.
4. Hang up.
 Voice Mail prompts your caller to leave a message in the mailbox you selected.
- OR -
1. Dial extension number or press a DSS Console key for the extension mailbox which receives the
transfer.
2. Press the Voice Mail key (Program 15-07 or SC 851: code 77 + InMail pilot)
- OR -
Press the Message key on the telephone, if equipped.
3. Hang up.
 Voice Mail prompts your caller to leave a message in the mailbox you selected.
Single Line Telephone
1. Hookflash.
Dial Voice Mail master number followed by destination mailbox.