1199
Guide to Feature Programming
Method A – Tandem Trunking from Conference:
Service Code Setup (for Service Access) –
Tandem Trunking
If the default service code (#8) for Tandem
Trunking is not acceptable, change the code as
required.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Basic Trunk Data Setup – Transmit Gain
Level for Conference and Transfer Calls
Select the Transmit CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
Basic Trunk Data Setup – Receive Gain
Level for Conference and Transfer Calls
Select the Receive CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
Basic Trunk Data Setup – Trunk-to-Trunk
Transfer
For each trunk that should be able to participate
in a tandem call, enter 1.
Programmable Function Keys
(Optional) Assign a function key for Transfer
(code 06).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Administrator
Level) – Forced Trunk Disconnect (analog
trunk only)
Turn Off or On an extension user ability to use
Forced Trunk Disconnect. This allows the
extension to disconnect an unsupervised
conference in progress.
Class of Service Options (Hold/Transfer
Service) – Trunk-to-Trunk Transfer
Restriction
Turn Off or On the Trunk-to-Trunk Transfer
Restriction. If enabled, Trunk-to-Trunk Transfer
is not possible.
Class of Service Options (Hold/Transfer
Service) – Restriction for Tandem Trunking
on Hang Up
Allow/Deny an extension user ability to set up a
tandem call automatically when they hang up.
To Next Page
Loading...
