NEC Univerge SV9100 - Trunk-To-Trunk Forwarding - DID (3) Trunk Forwarding by Dep. Groups

163
Program
Number
Program Name/Description
Input Data
Default
24-02-12
System Options for Transfer – No Answer
Trunk-to-Trunk Transfer
Define the time that elapses before the
automatic Trunk-to-Trunk Transfer is
performed.
0 ~ 64800 seconds
0
24-04-01
Automatic Trunk-to-Trunk Transfer Target
Setup
Assign the Speed Dialing number bin
(0 ~ 9999) to a trunk and the mode which
should be used as the destination of the
Automatic Trunk-to-Trunk Forwarding.
0 ~ 9999
9999
Trunk-to-Trunk Forwarding – DID (3) Trunk Forwarding by Department Groups:
 Refer to Department Calling for additional Department Group programming.
Program
Number
Program Name/Description
Input Data
Default
11-07-01
Department Group Pilot Numbers – Dial
Assign pilot numbers to the Extension
(Department) Groups you set up in Program
16-02.
Dial (maximum of eight digits)
No Setting
11-11-25
Service Code Setup (for Setup/Entry
Operation) – Automatic Transfer Setup for
Each Extension Group
Customize the service code to be used to set
the Automatic Trunk Forwarding feature for a
Department Group.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
702
11-11-26
Service Code Setup (for Setup/Entry
Operation) – Automatic Transfer
Cancellation for Each Extension Group
Customize the service code to be used to
cancel the Automatic Trunk Forwarding feature
for a Department Group.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
703
11-11-27
Service Code Setup (for Setup/Entry
Operation) – Destination of Automatic
Transfer Each Extension Group
Customize the service code to be used to set
the destination for the Automatic Trunk
Forwarding feature for a Department Group.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
704
13-01-01
Speed Dialing Function Setup – Speed
Dialing Auto Outgoing Call Mode
Determine if dialing an Speed Dialing number
will dial an outside number (seizing a trunk as
assigned in Program 13-05) or an Intercom
number (0 = Trunk Dialing Mode, 1 = Extension
Dialing Mode).
0 = Trunk Outgoing Mode
1 = Intercom Outgoing Mode
0