NEC Univerge SV9100 - Page 162

162
Program
Number
Program Name/Description
Input Data
Default
13-01-01
Speed Dialing Option Setup – Speed Dialing
Auto Outgoing Call Mode
Determine if dialing an Speed Dialing number
will dial an outside number (seizing a trunk as
assigned in Program 13-05) or an Intercom
number (0 = Trunk Dialing Mode, 1 = Extension
Dialing Mode).
0 = Trunk Outgoing Mode
1 = Intercom Outgoing Mode
0
13-04-01
Speed Dialing Number and Name – Speed
Dialing Data
Enter the Common and Group Speed Dialing
numbers and names which are to be used for
Trunk-to-Trunk Forwarding.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
14-01-26
Basic Trunk Data Setup – Automatic Trunk-
to-Trunk Transfer Mode
Enable (1)/Disable (0) each trunk ability to use
Step Transfer.
0 = Normal Transfer (Normal)
1 = Step Transfer (Step)
0
20-06-01
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to
extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-07-05
Class of Service Options (Administrator
Level) – Set/Cancel Automatic Trunk-to-
Trunk Transfer
Turn Off or On an extension user ability to use
the Trunk-to-Trunk Forwarding service codes.
0 = Off
1 = On
COS 1 ~ 15 = 0
22-02-01
Incoming Call Trunk Setup – Incoming Type
Assign the incoming trunk type for each trunk.
There is one item for each Mode. When using
Trunk-to-Trunk Forwarding the trunks must be
set for Normal (0).
Incoming Type for Day/Night
Mode (1 ~ 8):
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0
24-02-11
System Options for Transfer – No Answer
Step Transfer
Assign the amount of time each transfer
destination rings before step transfer is
performed.
0 ~ 64800 seconds
10