481
Flexible System Numbering
Description
Flexible System Numbering lets you reassign the system port-to-extension assignments. This allows an
employee to retain their extension number if they move to a different office. In addition, factory
technicians can make comprehensive changes to your system number plan. You can have factory
technicians:
Set the number of digits in internal (Intercom) functions. For example, extension numbers can have
up to eight digits.
Change your system Service Code numbers.
Assign single digit access to selected Service Codes.
Talk to your sales representative to find out if this program is available to you.
You can also use Flexible System Numbering to change the system Trunk Group Routing code.
Although the default code of 9 is suitable for most applications, you can alter the code if needed.
The system provides a completely flexible system numbering plan.
Flexible System Numbering
Program
Description
11-01-01 System Numbering
Set the system internal (Intercom) numbering plan. The
numbering plan includes the digits an extension user must
dial to access features and other extensions.
11-09-01 Trunk Access Code
Assign the single-digit trunk access code (normally 9). This
is the code users dial to access Automatic Route Selection
(ARS) or Trunk Group Routing.
11-20-01 Dial Extension Analyze Table
Use tables 01~128 to assign the digits to be dialed using the
Dial Extension Analyze Tables. These tables are used when
Program 11-01-01 is set to option 9 = Dial Extension
Analyze.
(Up to eight digits can be assigned and the valid entries are:
0, 1 ~ 9, #, *)
11-20-02 Dial Extension Analyze Table
Assign the Type of Dial for the Dial Extension Analyze Table
from Program 11-20-01.
(Svc Code, Intercom, Operator, or F-Route)
To Next Page
Loading...
General
