NEC Univerge SV9100 - Page 482

482
Flexible System Numbering (Continued)
Program Description
11-10 Service Code Setup (for System Administrator)
11-11 Service Code Setup (for Setup/Entry
Operation)
11-12 Service Code Setup (for Service Access)
11-13 Service Code Setup (for )
11-14 Service Code Setup (for Hotel)
11-15 Service Code Setup, Administrative (for
Special Access)
Customize the Service Codes.
11-16 Single Digit Service Code Setup
Assign the Single Digit Service Codes. these are the post-
dialing codes a user can dial after placing an Intercom call to
a co-worker.
Conditions
Programming follows a telephone extension number, not the port number in most cases. If you
relocate a telephone, you may need to change additional programming. For example, if you
change the extension assigned to a port in Program 11-02, the line key programming does
not follow. However, if you move the extension using the Station Relocation Feature, the
line key programming does follow.
Since making changes in Program 11-01 does not automatically make any other changes in
any other program, changing the number plan after the system is in operation may cause
problems in the following programs:
Program 11-01 Type 2 (Extension Number)
Program 11-01 Type 1 (Service Codes)
11-02
11-08
15-12
22-11
11-10
11-14
21-11
11-04
11-17
16-01-01
25-06
11-11
11-15
30-03
11-06
15-01-01
15-14
30-03
11-12
15-07
11-07
15-07
21-11
11-13
15-14
0507, 0515, 0516, 0920, 1207, 2402,
2902, 2905, 2908, 2402
Any feature which requires dialing a code or extension number can be affected.
When the system searches the Dial Extension Analyze Table (Program 11-20-01), the
system uses prefix searching, giving the lower table number the higher priority. For
example, the user programs 211 in table 1 and 2113 in table 2, then dials 2113, the system
selects table 1.