NEC Univerge SV9100 - To Call a Department Group; To Log out of Your Department Calling Group

337
Program
Number
Program Name/Description
Input Data
Default
22-02-01
Incoming Call Trunk Setup – Incoming Type
If you want a trunk to be a DIL to a Department
Group, assign Service Type 4 for each Night
Service Mode. Refer to Program 22-07-01.
Incoming Type for Day/Night
Mode (1 ~ 8):
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0
22-07-01
DIL Assignment
For each trunk assigned Service Type 4 in
Program 22-02-01 above, assign the DIL
destination as the Department Group pilot
number (as assigned in Program 11-07-01).
For this selection to work, set Program
22-02-01 to 4 (DIL).
Day/Night Modes (1 ~ 8):
Extension Number (maximum of
eight digits)
Pilot Number
No Setting
24-02-05
System Options for Transfer – Message Wait
Ring Interval Time
For Single Line Telephones (SLTs) without
message waiting lamps, this is the time
between intermittent ringing. If this value is set
to 0, the system rings once.
0 ~ 64800 seconds
30
24-02-08
System Options for Transfer – Delayed
Transfer Timer for All Department Groups
Determine the time a call should ring a
Department Group before transferring the call.
0 ~ 64800 seconds
10
24-05-01
Department Group Transfer Target Setup
Assign the Speed Dial bin to each Department
Group to hold the destination for the immediate
automatic transfer of ICM and transferred calls
to the Department Group feature.
0 ~ 9999
9999
Operation
To call a department group:
1. Go off-hook.
2. Dial department extension number.
 The system routes the call to the first free telephone in the department group.
3. Optional: To manually ring all members of the group, dial the single digit service code assigned
for All Member Ring (Program 11-16-10).
To log out of your Department Calling Group:
While you are logged out, Department Calling cannot route calls to your extension.
1. Press Speaker