1292
Maximum System Capacities for Trunk Interface Blades (Continued)
Maximum Capacities
Basic Port Expanded Port
Package
Package
The GCD-CCTA (Common Channel
Handler) is an optional blade that provides
a common channel signal through the
GCD-CCTA to a K-CCIS network and
controls the signaling between the KTS
and the CP00. Each GCD-CCTA blade
supports one K-CCIS link.
Four GCD-CCTA blades can be installed
per system. The T1 interface has a single
24 channel 64kb/s digital signal circuit
which can be configured either for T1
trunking.
The GCD-4ODTA Tie Line blade is an out
band dial type analog tie line interface
blade. This blade supports system
connections to either 2-wire (four lead, tip/
ring) or 4-wire (eight lead, tip/ring/tip 1/
ring 1) E&M signaling tie lines (determined
in Program 10-03). System programming
is also used to select the connection types
with Type 1 or Type V.
The GCD-4ODTA consumes 4 ports
ranging between ports 001~200. This
blade is installed in slots 2-6 of a chassis
with CPU and slots 1-6 of expansion
chassis. The maximum number depends
on other trunk blades installed. This blade
shares the total number of CO/PBX lines
in the system.
Note 1: Calculating maximum capacities are based on the system having a minimum of eight Digital Line (DLC) ports, four
trunk ports.
Note 2: Refer to Table 2-127 Board Power Factor on page 2-1558.
Maximum System Capacities for Application Interface Blades
Application Interface
Blades
Maximum Capacities
Basic Port Expanded Port
Package
Package
This GCD-VM00 is a PC platform that
contains data storage for voice recording
and application software supporting a
maximum of 16 ports.
To Next Page
Loading...
