NEC Univerge SV9100 - Automatic Route Selection

66
Guide to Feature Programming
Automatic Route Selection:
Program
Number
Program Name/Description
Input Data
Default
11-01-01
System Numbering
Set the system internal
(Intercom) numbering plan. The
numbering plan assigns the first
and second digits dialed and
affects the digits an extension
user must dial to access other
extensions and features, such
as service codes and trunk
codes. If the default numbering
plan does not meet the site
requirements, use this program
to tailor the system numbering to
the site.
11-09-01
Trunk Access Code
Specify the digit or digits to be used to access
ARS (normally 9).
Dial up to four digits.
9
11-09-02
2nd Trunk Route Access Code
Define additional trunk access codes. When a
user dials the Alternate Trunk Route Access
Code, the system routes their call to the
Alternate Trunk Route.
Dial up to four digits.
No Setting
12-01-01
Night Mode Function Setup – Manual Night
Mode Switching
Turn Off or On any extension from activating
Manual Night Service.
0 = Off
1 = On
1
12-01-02
Night Mode Function Setup –Automatic
Night Mode Switching
According to a preset schedule, Enable (1)/
Disable (0) Automatic Night Service for the
system. Make sure to set the Service Patterns
in Program 12-02-01, Program 12-02-02 and
Program 12-02-03.
0 = Off
1 = On
0