NEC Univerge SV9100 - To Enter an Account Code at a Single Line Telephone; To Enter an Account Code for an Incoming Call

17
- OR -
Press your Account Code key (Program 15-07 or SC 851: code 50).
3. Dial your Account Code (1~16 digits, using 0~9 and #).
 If you make an incorrect entry, your system may automatically alert the operator. If Account Codes
are hidden, each digit you dial shows * on the telephone display.
4. Dial *.
- OR -
Press your Account Code key (Program 15-07 or SC 851: code 50).
5. Dial the number you want to call.
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
 If Account Codes for Incoming Calls is disabled, the following steps dial digits out to the connected
trunk.
2. Dial * .
3. Enter the Account Code.
 You can enter any code of the proper length. Incoming Account Codes cannot be Forced or Verified.
4. Dial * .
To enter an Account Code at a single line telephone:
1. Access trunk for outside call.
 Dial a code to access a trunk.
2. Dial *
3. Enter Account Code (1~16 digits).
4. Dial * .
5. Dial number you want to call.