NEC Univerge SV9100 - Delay Announcement

607
Program
Number
Program Name/Description
Input Data
Default
80-04-01
Call Progress Tone Detector Setup – Detect
Level
Define the various levels and timers for the Call
Progress Tone Detector.
Use this option to set the Detection Level.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
Type 1 (DT) – 0
(-25dBm)
Type 2 (BT) – 0
(-25dBm)
Type 3 (RBT) – 0
(-25dBm)
Type 4 (SBT) – 0
(-25dBm)
Type 5 – 0
Delay Announcement:
Only use if Announcement Mailboxes are used for Delay Announcements.
Program
Number
Program Name/Description
Input Data
Default
41-19-01
Voice Mail Delay Announcement – Delay
Message Start Timer
Determine the time the system waits before
playing the Delay Message.
0 ~ 64800 seconds
0
41-19-02
Voice Mail Delay Announcement – Mailbox
Number for 1st Announcement Message
Assign Voice Mail Announcement Mailbox as
the message source for the 1st Announcement
Message.
Dial (maximum of eight digits)
No Setting
41-19-03
Voice Mail Delay Announcement – 1st Delay
Message Sending Count
Determine the 1st Delay Message Sending
Count. This entry must be set to 1 or higher for
the message to play.
0 = No message is played.
1 ~ 255
0
41-19-04
Voice Mail Delay Announcement – Mailbox
Number for 2nd Announcement Message
Assign Voice Mail Announcement Mailboxes
as the message source for the 2nd
Announcement Message.
Dial (maximum of eight digits)
No Setting
41-19-05
Voice Mail Delay Announcement – 2nd Delay
Message Sending Count
Determine the 2nd Delay Message Sending
Count. This entry must be set to 1 or higher for
the message to play.
0 = No message is played.
1 ~ 255
0
41-19-06
Voice Mail Delay Announcement – Wait Tone
Type at Message Interval
Determine what the caller hears between the
messages.
0 = Ring Back Tone
1 = Music On Hold Tone
2 = Background Music Source
0