NEC Univerge SV9100 - DT330 Compatibility Settings

1183
Terminal and Adapter Compatibility (DT400/DT800)
Terminal
ADA-L
Adapter Unit
APR-L
ILPA
*
BHA-Z
BCA-Z
ITZ-24D-3 (BK)/(WH) TEL
—
—
ITZ-12CG-3 (BK)/(WH) TEL
—
—
ITZ-12DG-3 (BK)/(WH) TEL
—
—
ITZ-8LDG-3 (BK)/(WH) TEL
—
—
Console:
DCZ-60-2 (BK)/(WH) CONSOLE
—
—
—
—
*
= When the ILPA-R unit is used, 1000 BASE-T is not available.
DT330 Compatibility Settings
ADA-L Unit Switch Settings
xxx I Lx or lower
(Version 1.E0 or lower)
Terminal Lot Number DT-330
xxx I Mx
(Version 8.10)
xxxJSx or higher
(Version 2.20 or higher)
ADA Connection for
Recording Only.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches 4
and 6 are ON.
ADA Connection for
Sending Recorded Calls
to the Telephone.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
To Send and Receive to
the Terminal
Not supported
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches 4
and 6 are ON.
Lot Numbers: I, J – Hardware Revision
Lot Numbers: L, M, S – Software Revision
To verify DT-330 terminal firmware, hold down keypad buttons 1, 2 and 3 while plugging the line cord into the
terminal.