NEC Univerge SV9100 - Conversion Exception; Supported Terminals

870
Supported Terminals
SV8100 Supported Terminals
Terminal Supported
Dterm80/85 (DTH & DTR)
No
DT300 Series (DTL)
Yes
DT400 Series (DTL)
Yes
DT700 Series (ITL)
Yes
DT800 Series (ITL)
Yes
MH240
No
ML440
Yes
Bluetooth Cordless Handset (BCH)
Yes
SLT
Yes
SIP Terminal
Yes
IP-DECT
Yes
Softphone
No
DTL-8R-1 Cordless terminal
Yes
Cordless terminals (DTH-4R-1/DTR-1R-2) are not supported.
Conversion Exception
SV8100 Conversion Exception
SV8100 Program
Number
SV9100 Program
Number
Comments
10-03 (VoIP)
10-68
The conversion of data for VOIP does not support conversion.
10-40
14-18
The VOIP package of SV8100 is deleted after conversion
completion. Please set VOIP package with blade configuration.
Thereafter IP trunks are set in Program 10-68.
10-26-01
15-05-50
The conversion of IP system communication mode, the peer to
peer mode does not support conversion. It is changed to the
extension terminal-based setting. After conversion completion,
Please set Program 15-05-50.
10-26-03
15-05-50
The conversion of IP system communication mode, the peer to
peer mode does not support conversion. It is changed to the
extension terminal-based setting. After conversion completion,
Please set Program1 5-05-50.
10-29-08
10-67-01
The conversion of SIP server information, DNS server setting
10-29-09
10-67-02
does not support conversion. Please set Programs 10-67-01,
10-29-10
10-67-03
10-67-02 and 10-67- 03.
84-32-01 ~ 84-32-07
84-33-12 ~ 84-33-18
The conversion of Fax over IP Codec information does not
support conversion. Please set Program 84- 33 for every type.
84-01-69 ~ 84-01-71
84-35-01 ~ 84-35-03
The conversion of RFC2833 play out level setting does not
support conversion. Please set Program 84- 35 for every type.