1303
Class of Service Options (Supplementary
Service) – Busy on Seizing Virtual Extension
If set to 1, you can call a busy extension which
is talking on a virtual extension key. Program
20-13-06 (Call Waiting) must be Off for this
option to work.
Ring Cycle Setup – Incoming Internal Call
Define ringing cycle for incoming Internal calls.
System Options for Outgoing Calls –
Outgoing Disable on Incoming Line (Toll
Restriction)
Enable/Disable the Outgoing Disable on
Incoming Line feature.
Trunk Ring Tone Range
Select the ring tone range for the trunk. The
trunk uses a ring tone in the range selected
when it rings an extension. Eight ring tones are
available.
0 ~ 12
(Ring Tone Pattern 1 ~ 4)
(Melody 1 ~ Melody 5)
(Ring Tone Pattern 5 ~ 8)
Ringing Line Preference for Virtual
Extensions
When an extension has a virtual extension on
Function Key, this program determines the
priority (1 ~ 4) for a Ring Group for
automatically answering ringing calls when the
handset is lifted. If (00) is selected for the Ring
Group, when the handset is lifted, the user can
answer a ringing call from any group.
00 ~ 64
(0 or 00 = Don’t Care)
Operation
To answer a call ringing a Virtual Extension:
1.
Press the flashing Virtual Extension key.
- OR -
Go off-hook.
Program 20-10-08 needs to be set to on (1) for extension Class of Service.
To place a call to a Virtual Extension:
1.
Go off-hook.
2.
Dial the Virtual Extension, or press the Virtual Extension key.
The operation depends on the setting in Program 15-02-21.
To place a call from a Virtual Extension:
1.
Press the Virtual Extension key.
The operation depends on the setting in Program 15-02-21.
2.
Place an intercom call or dial a trunk access code to seize an outside line and place your call.
To Next Page
Loading...
