913
Basic Tone Number
Customize the basic tone number for the music
on hold tone if Program 10-04-01 is set to 2.
0 ~ 33
(0 = No Tone)
(33 = Default Time Slot)
Duration Count
Customize the duration count for the music on
hold tone if Program 10-04-01 is set to 2.
Gain Level (dB)
Customize the Gain Level for the music on hold
tone if Program 10-04-01 is set to 2.
When Using a PGD(2)-U10 ADP:
ETU Setup (DLCA PKG Setup) – Terminal
Type (B1)
If a PGD(2)-U10 ADP is used for the external
music source, the module is automatically
assigned type 9 if the jumper straps in the
module were set prior to connecting it to the
system. If another type was assigned,
disconnect the PGD(2)-U10 ADP from the
system, delete the type setting, and, with the
jumper straps positioned correctly in the
PGD(2)-U10 ADP, reconnect the module to the
system. Refer to the UNIVERGE SV9100
System Hardware Manual for the jumper strap
settings.
0 = Not set
1 = Multiline Terminal
3 = Bluetooth Cordless Handset
6 = PGD (Paging)
7 = PGD (Tone Ringer)
8 = PGD (Doorbox)
9 = PGD (ACI)
10 = DSS Console
11 = -- Not Used --
ACI Extension Numbering
Each ACI port must be assigned an extension
number. Assign the extension numbers to ACI
software ports. Select a number outside of the
normal extension number range.
Maximum of eight digits.
ACI Ports: 1 ~ 96
ACI Group Pilot Number
Assign pilot numbers to ACI groups. When a
user dials the pilot number, they reach an
available ACI software port within the group.
Dial (maximum of eight digits).
ACI Groups 1 ~ 16
DID Translation Number Conversion – Music
On Hold Source
For each DID Translation Table entry
(1 ~ 4000), specify the source of music to be
used for DID trunks.
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
To Next Page
Loading...
