NEC Univerge SV9100 - Page 914

914
Program
Number
Program Name/Description
Input Data
Default
33-01-01
ACI Port Type Setup
Set each ACI software port for Input or Input/
Output. Use input ports for Music on Hold
sources. Use output ports for External Paging/
Ringer Control.
ACI Ports: 1 ~ 96
ACI Types:
0 = None
1 = MOH/BGM (Input)
2 = External Audio Port
(Input/Output)
2
33-02-01
ACI Department Calling Group
Assign ACI software ports to an ACI
Department Group. This lets ACI callers
connect to ACI software ports by dialing the
group pilot number (set in Program 11-08).
ACI Ports: 1 ~ 96
ACI Groups: 1 ~ 16
ACI Port/Group/
Priority
01/ 1/ 1
02/ 1/ 2
: / :/ :
96/ 1/ 96
Refer to Analog
Communications
Interface (ACI)
for additional
information.
80-01-02
Service Tone Setup – Basic Tone Number
The following features require that the system
tones listed below be changed to match the
table. After changing these settings the chassis
must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
1 ~ 33
(0 = No Tone)
(33 = Default Time Slot)
33 = Default
Time Slot
Refer to Service
Tone Setup,
Program 80-01-
02