NEC Univerge SV9100 - ISDN - PRI Network Specific Assignment; SMDR Dialed Digits for Either ISDN - BRI or PRI

804
ISDN – PRI Network Specific Assignment:
Program
Number
Program Name/Description
Input Data
Default
26-02-07
Dial Analysis Table for ARS/LCR – Network
Specified Parameter Table
Define the network specified parameter table
for each ARS Table.
0 ~ 16
0
26-12-01
Network Specific Parameter Table for ARS –
Type of Number
Define the type of Number parameter for an
ISDN outgoing call.
0 = System Default
1 = Unknown
2 = International No.
3 = National No.
4 = Network Specific No.
5 = Subscriber No.
6 = Abbreviated No.
0
26-12-02
Network Specific Parameter Table for ARS –
Numbering Plan Identification
Define the Numbering Plan Identification
Parameter for an ISDN outgoing call.
0 = System Default
1 = Unknown
2 = ISDN Plan
3 = Data Plan
4 = Telex Plan
5 = National Standard Plan
6 = Private Plan
0
44-05-11
ARS/F-Route Table – Network Specified
Parameter Table
Define the network specified parameter table
for each F-Route table.
0 ~ 16
0
SMDR Dialed Digits for either ISDN – BRI or PRI:
Program
Number
Program Name/Description
Input Data
Default
35-02-15
SMDR Output Options – CLI/DID Number
Switching
Determine if the CLI/DID Number should be
displayed.
0 = CLI (CLIP)
1 = DID Calling Number
2 = Caller ID Name
0
35-02-16
SMDR Output Options – Trunk Name or
Received Dialed Number
Determine how the SMDR should print
incoming calls on ANI/DNIS or DID trunks. If set
to 1, ANI/DNIS trunks can print DNIS digits, if
set to 0 trunk names are printed instead.
For additional SMDR Services refer to Station
Message Detail Recording.
0 = Trunk Port Name
1 = Received Dialed Number
0