NEC Univerge SV9100 - Page 912

912
Program
Number
Program Name/Description
Input Data
Default
10-21-04
GCD-CP10 Hardware Setup – External
Source I/O Selection on GCD-CP10
Define how the I/O ports on the GCD-CP10 are
used.
0 = External MOH (AUX2)/
External Speaker(AUX1)
1 = BGM source (AUX2)/
External Speaker(AUX1)
2 = External MOH (AUX2)/
BGM source (AUX1)
Relationships between AUX
number and Relay number are as
follows:
AUX2 = Relay2
AUX1 = Relay1
1
14-08-01
Music on Hold Source for Trunks – MOH
Type
Set the Music on Hold source for each trunk.
0 = Internal/External MOH
1 = Customer Provided Source
Connected to BGM Port
2 = Customer Provided Source
Connected to ACI Port
0
14-08-02
Music on Hold Source Port Number –
Source Port Number
If the MOH type is 2 in Program 14-08-01, for
each trunk enter the ACI source port number
(1 ~ 96).
Source port 0 ~ 96
0
20-06-01
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-07-02
Class of Service Options (Administrator
Level) – Changing the Music on Hold Tone
Turn Off or On an extension user ability to
change the Music on Hold tone.
0 = Off
1 = On
COS 1 ~ 14 = 0
COS 1 ~ 15 = 1
22-11-09
DID Translation Number Conversion – Music
On Hold Source
For each DID Translation Table entry
(1 ~ 4000), specify the source of music to be
used for DID trunks.
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
0
22-11-10
DID Translation Number Conversion – ACI
Music Source Port
For each DID Translation Table entry
(1 ~ 4000), if item 2 is selected in Program
22-11-09, specify the port to be used for the
source of music heard on DID trunks.
When a sound source type is 2
in above: (0 ~ 96)
0
80-01-01
Service Tone Setup – Music On Hold Tone
(Service Tone 64)
Customize the repeat count for the music on
hold tone if Program 10-04-01 is set to 2.
0 ~ 255 (0 = Until On-Hook)
0
Refer to Table 2-
31 Service Tone
Setup Defaults,
Program
80-01-01