NEC Univerge SV9100 - Page 528

528
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
15-07-01
Programmable Function Keys
Assign a function key for Handset Transmission
Cut Off (code 40).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
80-01-01
Service Tone Setup – Repeat Count
Customize the system basic tones and system
service tones. The system must be reset for
the changes to take effect.
0 ~ 255
(0 = until On-Hook)
Refer to Table 2-
31 Service Tone
Setup Defaults,
Program
80-01-01
80-01-02
Service Tone Setup – Basic Tone Number
The following features require that the system
tones listed below be changed to match the
table. After changing these settings the system
must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
1 ~ 33
(0 = No Tone)
(33 = Default Time Slot)
(33 = Default
Time Slot)
Refer to Table 2-
32 Service Tone
Setup, Program
80-01-02
Service Tone Setup Defaults, Program 80-01-01
Service
Tone No.
Service Tone
Repeat
Count
Unit
Count
Basic
Tone No.
Duration
Gain Level
(dB)
1
No Tone
0
Basic 1
0
10
32 (0dB)
2
Internal Dial Tone
0
Basic 1
9
10
32 (0dB)
3
Stutter Dial Tone
0
Basic 6
0
2
32 (0dB)
9
1
0
1
9
1
0
1
9
77