1080
IPL Basic Setup – Maximum MCU Group
Number (Mode 1)
Used to reserve VoIP DSP resources for mode
1 video conferences. When a DSP resource is
reserved it is not available for SIP voice calls.
VoIP DSP resources are shared between video
and voice calls. The system will always keep 64
resources for voice calls. When changing this
program if resources are exceeded the system
will provide an error message and will not allow
the setting to be changed.
When changing this program, all DSP
resources are reset when idle. In progress calls are
not affected, but until all DSP resources go idle this
change will not take affect.
0 = No MCU video channels
reserved
1 = 4 MCU video Mode 1
channels reserved
IPL Basic Setup – Maximum MCU Group
Number (Mode 2)
Used to reserve VoIP DSP resources for mode
2 video conferences. When a DSP resource is
reserved it is not available for SIP voice calls.
VoIP DSP resources are shared between video
and voice calls. The system will always keep 64
resources for voice calls. When changing this
program if resources are exceeded the system
will provide an error message and will not allow
the setting to be changed.
When changing this program, all DSP
resources are reset when idle. In progress calls are
not affected, but until all DSP resources go idle this
change will not take affect.
0 = No MCU video channels
reserved
1 = 4 MCU video Mode 1
channels reserved
VoIPDB DTMF Setup – DTMF Relay Mode
Set DTMF mode for standard SIP extensions.
The recommended method is RFC2833.
Type 3 SIP Extensions, profile 1.
0 = Disable
1 = RFC2833
2 = H.245
VoIPDB DTMF Setup – DTMF Payload
Number
Set DTMF Payload for standard SIP
extensions.
Type 3 SIP Extensions, profile 1.
VoIPDB DTMF Setup – DTMF Detection Type
Type 3 SIP Extensions, profile 1.
VoIPDB DTMF Setup – DTMF Transmit Type
Type 3 SIP Extensions, profile 1.
VoIPDB DTMF Setup – DTMF Rely (inband)
Retransmit Type
Type 3 SIP Extensions, profile 1.