NEC Univerge SV9100 - Page 1089

1089
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-12-13
GCD-CP10 Network Setup – DNS Primary
Address
Set the IP Address of the Primary DNS server.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-14
GCD-CP10 Network Setup – DNS Secondary
Address
Set the IP Address of the Secondary DNS
server.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-15
GCD-CP10 Network Setup – DNS Port
Set the port number of the DNS server.
0 ~ 65535
53
90-64-01
SNMP Setup – SNMP
Set to enable the SNMP feature.
0 = Disable
1 = Enable
0
90-64-02
SNMP Setup – Community Name
Enter the SNMP community name.
Maximum of 12 characters.
Public
90-64-03
SNMP Setup – Target Host 1
Enter the IP Address of the PC running the
SNMP application.
XX.XX.XX.XX
0.0.0.0
90-64-04
SNMP Setup – Target Host 2
Enter the IP Address of the PC running the
SNMP application.
XX.XX.XX.XX
0.0.0.0
90-64-05
SNMP Setup – Target Host 3
Enter the IP Address of the PC running the
SNMP application.
XX.XX.XX.XX
0.0.0.0
90-64-06
SNMP Setup – Target Host 4
Enter the IP Address of the PC running the
SNMP application.
XX.XX.XX.XX
0.0.0.0
90-64-07
SNMP Setup – Target Host 5
Enter the IP Address of the PC running the
SNMP application.
XX.XX.XX.XX
0.0.0.0
90-64-08
SNMP Setup – Domain Name
Enter the Domain name.
Maximum of 255 characters.
0.0.0.0
90-64-09
SNMP Setup – Trap Set Message
When Disabled, the trap message is sent to the
SNMP application for Major and Minor Alarms.
When Enabled, all trap messages set to the
SNMP application are sent.
When Program 90-64-09 is disabled, all
alarms that are Minor or Major are output as a trap
message. For each Alarm in Program 90-10, it is
possible to set the Alarm type to Major, Minor and
Not Set. With Program 90-64-09 disabled, any
alarms set to Not Set are not trapped.
0 = Disable
1 = Enable
0
90-64-10
SNMP Setup – Trap Message of System Data
Change
Enable this item to send trap messages for
system data changes to the SNMP manager.
0 = Not Send
1 = Send
0