NEC Univerge SV9100 - Page 111

111
Program
Number
Program Name/Description
Input Data
Default
20-20-01
Message Setup for Non-Caller ID Data –
Private Call
Enter the text to be displayed for Caller ID when
a user receives a call which is classified as a
private call.
24 Alphanumeric Characters
PRIVATE
20-20-02
Message Setup for Non-Caller ID Data – Call
from Out of Service Area
Enter the text to be displayed for Caller ID when
a user receives a call which is classified as an
out-of-service area call.
24 Alphanumeric Characters
OUT OF AREA
20-20-03
Message Setup for Non-Caller ID Data – Call
Information with Error
Enter the text to be displayed for Caller ID when
a user receives a call which is classified as a
call with a CID error.
24 Alphanumeric Characters
NO CALLER
INFO
90-03-01
Save Data
Save the programmed data on the SRAM and
Flash ROM to the 16MB/32MB ATA removable
Compact Flash memory card.
Also, used to save stored Caller ID if
permanently saved with service code #*#9
(11-15-03).
This program is available only via telephone
programming and not through PC Programming.
Dial 1 + press Transfer (Press
Transfer to cancel.)
No Setting
90-04-01
Load Data
Load the system data from the inserted
Compact Flash Memory to the SRAM and
Flash ROM in the system.
Also, used to load stored Caller ID.
This program is available only via telephone
programming and not through PC Programming.
Dial 1 + press Transfer (Press
Transfer to cancel.)
No Setting