NEC Univerge SV9100 - Page 1121

1121
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-11-56
Service Code Setup (for Setup/Entry
Operation) – Telephone Book Lock Service
Password to unlock telephone book.
Dial the service code to lock the telephone
book (Program 11-11-56), then it prompts
you for an extension number to unlock.
Type in the ext number you want to unlock
then you will be prompted for the password.
Type in the password and then the
telephone book is unlocked. When you dial
the password to unlock the telephone book it
removes the entry in 15-19-06 so the book is
not locked anymore.
To lock the telephone book do the same
steps as above when the book is already
unlocked. It will then assign 15-19-06 for
you.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
13-07-01
Telephone Book Dial Number and Name –
Speed Dialing Data
Assign telephone numbers to entries in each
book. There are 200 books with 450 entries
(0-449) in each book.
Maximum of 24 digits
1~9, 0, *, #,
Pause (Press line key 1),
Recall/Flash (Press line key 2),
@ = Code to wait for answer
supervision in ISDN (Press line
key 3)
No Setting
13-07-02
Telephone Book Dial Number and Name –
Name
Assign a name to each telephone number.
Maximum of 12 digits
(Use dial pad to enter name)
No Setting
13-07-04
Telephone Book Dial Number and Name –
Group Number
Assign each entry in the telephone book to a
group if needed.
In the telephone book you can break it down
further and have specific groups to search on. For
example, you could have sales, support, personal,
finance, etc. groups to narrow your search.
A name and number can be assigned to an
entry and each entry can be assigned to a group.
1 ~ 40
1