NEC Univerge SV9100 - Page 1162

1162
Registered SIP trunks can be utilized by any system in the NetLink network as long as trunk
route programming allows it.
When a secondary system becomes the primary after fail over, the SIP trunks will work for
the effective license time.
Program 51-01-04 selects the packet sending method whether each packet is sent
immediately or after buffering some packets across the network. This program needs to be
set at each system and it is recommended all systems have same setting.
Default Settings
None
System Availability
Terminals
All Terminals
Required Component(s)
GCD-CP10 Blade with GPZ-IPLE
SD-B1(4GB) card
SV9100 NETLINK NODE License
Related Features
 Automatic Route Selection (ARS)
Guide to Feature Programming
 The items highlighted in gray are read only and cannot be changed.
Program
Number
Program Name/Description
Input Data
Default
10-12-03
GCD-CP10 Network Setup – Default
Gateway
Define the default gateway to be used by the
GPZ-IPLE interface.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-09
GCD-CP10 Network Setup – IP Address
Set IP address for GPZ-IPLE.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
172.16.0.10