1165
NetLink Internet Protocol Address List
Setting – Internet Protocol Address List
The system seeks the Primary system based
on this list.
When there is no Primary system yet, or Fail
Over occurs, Node List is referred to establish
new link. This setting is necessary when
Program 51-01-03 is 0, or Program 51-05-02 is
other than 0.
Once the system connects to the Primary
System, this setting is updated by the Primary
system when Program 51-13-01 is On. So,
enter IP address of the systems which may
become Primary at least.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
IP Address Setting of Top Priority Primary
System of Net-Link – Internet Protocol
Address of Top Priority Primary
Enter the IP address of the Top Priority Primary
System.
To use this feature, set Program 51-06-01 to
1(On).
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
NetLink Timer Settings – Keep Alive
Sending Interval
This is the Keep Alive sending time from the
Secondary system to confirm communication
with the Primary system.
NetLink Timer Settings – Keep Alive
Response Waiting Time
This is the time the Secondary system waits for
a response from the Primary system before
cutting off communication.
0, 5 ~ 10800 seconds
(0 = infinity)
NetLink Timer Settings – Primary Search
Packet Sending Interval
While searching the Primary system, the
system sends a packet at this time.
NetLink Timer Settings – Primary Search
Time Maximum Value
Total time of Primary system seek time.
NetLink Timer Settings – Top Priority
Primary Detection Packet Sending Interval
When current Primary system is not Top Priority
Primary System, the system sends packet to
check if Top Priority System exists.
NetLink Timer Settings – Primary
Compulsion Specification Trial Maximum
Time
When the forced change Primary command is
executed, the system searches the new
Primary system for this time.
To Next Page
Loading...
