NEC Univerge SV9100 - Page 1167

1167
Program
Number
Program Name/Description
Input Data
Default
51-09-01
NetLink Communication Port Settings –
Primary Waiting Port
Set the communication port that the Primary
system uses to communicate with the
Secondary system.
0 ~ 65535
58000
51-09-02
NetLink Communication Port Settings –
Communication Waiting Port
Set the Port used to communicate between
nodes. It is always opened by all nodes.
0 ~ 65535
58001
51-09-03
NetLink Communication Port Settings –
Secondary Communication Port
Secondary system communicates with Primary
system at this port number. If 0 is specified,
temporary port is dynamically selected.
0 ~ 65535
0
51-09-04
NetLink Communication Port Settings –
Primary Search Port
When Fail-Over occurred, each system
communicates with other system at this port
number.
If 0 is set, temporary port is selected
dynamically.
If 0 is not specified, the number and continuous
maximum 50 number is used.
(e.g. 5000 is specified 5001, 5002…5049 are
used).
0 ~ 65535
0
51-09-05
NetLink Communication Port Settings –
Primary Detection Port
Enter port number to seek the Top Priority
Primary system.
If 0 is specified, temporary port is selected
dynamically.
0 ~ 65535
0
51-09-06
NetLink Communication Port Settings –
Database Replication Communication
Listening Port
Set the port used to replicate database.
0 ~ 65535
58002
51-09-07
NetLink Communication Port Settings –
Database Replication Primary Detection
Port
Set the port used to replicate database.
If 0 is specified, temporary port is selected
dynamically.
0 ~ 65535
0
51-10-01
Virtual Slot Setting – Number of Available
Virtual Slots
240 slots can be controlled in NetLink. This
command can check how many slots are
available.
240 slots can be controlled in
NetLink. This command can
check how many slots are
available.
No Setting
51-11-01
NetLink System Information – System Name
For reference only.
For reference only.
No Setting