NEC Univerge SV9100 - Page 1228

1228
Program
Number
Program Name/Description
Input Data
Default
20-13-15
Class of Service Options (Supplementary
Service) – Barge-In, Initiate
Turn Off or On an extension user ability to
barge-in on other's calls.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-13-16
Class of Service Options (Supplementary
Service) – Barge-In, Receive
Turn Off or On an extension user ability to have
other extensions Barge-In on calls.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-13-17
Class of Service Options (Supplementary
Service) – Barge-In Tone/Display (Intrusion
Tone)
Turn Off or On the Barge-In Tone. If set to 1,
callers hear an alert tone and their display
indicates the Barge-In when another extension
barges into their conversation. If set to 0, there
is no alert tone or display indication.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-32
Class of Service Options (Supplementary
Service) – Deny Multiple Barge-Ins
Allow/Deny an extension user ability to have
multiple users Barge-In to their conversation.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-14-11
Class of Service Options For DISA/E&M –
DISA/Tie Trunk Barge-In
Enable/Disable a DISA or tie trunk user ability
to use Barge-In.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-18-07
Service Tone Timers – Intrusion Tone
Repeat Time
After a call is interrupted (such as Barge-In,
Voice Mail Conversation Recording or Voice
Over) the system repeats the Intrusion tone
after this time. Normally, you should enter 0.
0 ~ 64800 seconds
0
21-01-03
System Options for Outgoing Calls – Trunk
Interdigit Time (External)
The system waits for this time to expire before
placing the call in a talk state (Call Timer starts
after time expires, Voice Over and Barge-In are
not allowed until after time expires).
0 ~ 64800 seconds
5
22-04-01
Incoming Extension Ring Group
Assignment
Assign extensions (up to 48) to Ring Groups.
Calls ring extensions according to Ring Group
programming. There are 100 available ring
groups.
Maximum of eight digits.
Extensions
101 ~ 108 (first
eight ports) ring
for incoming
Ring Group 1
calls. No other
extensions ring
for incoming
Ring Group 1
calls.
22-05-01
Incoming Trunk Ring Group Assignment
Define a trunk ring group. When transferring a
DID or trunk call to the trunk defined ring group,
the trunk then rings the defined extensions for
the ring group.
Trunks 1 ~ 400
Incoming Group Number for
Day/Night Mode (1 ~ 8):
0 = (No Setting)
001 ~ 100 = (Incoming Group)
102 = (In-Skin/ External Voice
Mail or InMail)
103 = (Centralized VM)
1