NEC Univerge SV9100 - Page 1259

1259
45-01-05
Voice Mail Integration Options – Message
Wait
Enable/Disable the system ability to process
the Voice Mail Message Wait (#) commands.
You should normally enable this option. If
enabled be sure the Programmed Message
notification strings do not contain the code for
trunk access.
When using Centrex transfer from a voice mail
port the following items must be considered:
If the Feature Access Code starts with # in
Program 11-12-42 set Program 45-01-05 to
0.
When assigning the dial string in voice mail,
one or more “Pauses” may be needed too,
depending on what Telco needs.
0 = Off
1 = On
1
45-01-06
Voice Mail Integration Options – Record
Alert Tone Interval Time
Set the time between Voice Mail Conversation
Record alerts.
0 ~ 64800 seconds
30
45-01-18
Voice Mail Integration Options – Trunk
Number Mapping
Assign the digits of trunk number mapping.
2 ~ 3
2
80-01-02
Service Tone Setup – Basic Tone Number
Customize the systems service tones.
0 ~ 33
0 = No Tone
33 = Default Time Slot
80-03-01
DTMF Tone Receiver Setup – Detect Level
Customize the Detect Level for DTMF Tone
Receivers.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
Type 1 ~ 5 = 0
80-03-02
DTMF Tone Receiver Setup – Start Delay
Time
Define the start delay time for DTMF Tone
Receiver.
0 ~ 255
(0.25ms ~ 64ms)
Type 1 ~ 5 = 0