NEC Univerge SV9100 - Page 1287

1287
SV9100 9.5” (Base and Expansion) Maximum System Capacities – Trunks/Ports/Channels
9.5” Base 9.5” Base + Expansion
Number of: x 1
System
(CPU + 2
x 1 x 2 x 3 X4 Maximum
Slots)
(6 Slots) (12 Slots) (18 Slots) (24 Slots)
Number of Timeslots
*
1
PCM
48
104
208
312
416
444
Data
7
7
14
21
28
28
DT400/DT300 TDM (-48V)
32
80
176
272
368
Total 896
SLT (-28V)
32
80
176
272
368
SLT (-48V)
8
20
44
68
92
DT800/DT700 IP
896
Desktop Applications
(Desktop Client, Desktop Client with
Shared Services and SoftPhones)
256
Total 256
SIP/WLAN
896
Total 896
Analog Trunks (COT)
16
40
88
136
184
Total 400
BRI
16
40
88
136
184
PRI (1.5M)
48
96
192
192
192
IP Trunk (SIP/K-CCIS – IP)
400
DTMF Receivers
80
80
144
144
144
*
2
VoIP Channels
256
256
Voice Mail Channels on CPU
16 channels
16
V34 Modem
1 channel
1
*
1 = For -law countries 104 timeslots per chassis are assigned the G.711 PCM communications (e.g., voice
communications) and 7 timeslots per chassis are assigned for the Data communications (e.g., HDLC over
ISDN). Thus the simultaneous data communications are limited up to seven per chassis.
*
2 = An additional 64 DTMF Receivers are available when the GPZ-BS10 is installed.
An additional 64 DTMF Receivers are available when the GPZ-BS10 is installed.
If using Caller ID to analog trunks and DSP resources are set to common, DSP resources will only be used for analog
trunks and not analog stations.
Each Universal Slot is capable of 24 ports.
The Basic Port Package is limited to one chassis.
The PRTA blades can be programmed as a 4/8/12/16/20/24 port Fractional T1/PRI.
Program 10-39-01 must be Enabled).
If trying to assign an blade which would excede the maximum number of ports for the Basic
Port Package you do not get an error, but it does not let you program the related programs.
The 9.5" chassis can now accommodate two GCD-LTA (combo) blades in the universal
slots. Both blades can be viewed and accessed via PC Pro.