NEC Univerge SV9100 - Page 1348

1348
Program
Number
Program Name/Description
Input Data
Default
25-08-01
DISA User ID Setup – Password
Set up password (six digits).
Dial (Six digits fixed)
(0 ~ 9, *, #)
No Setting
25-13-01
System Option for DISA – VRS Message
Access Password
Enter the password DISA callers must dial
before the system allows them to record, listen
to or erase VRS messages.
Six digits fixed
(0 ~ 9, *, #)
No Setting
25-15-01
DISA Transfer Target Setup – DISA Transfer
Target Area at Wrong Dial
Used to assign a speed dial number when the
wrong number is received.
Speed Dial bin number 0 ~ 1999
1999
25-15-02
DISA Transfer Target Setup – DISA Transfer
Target Area at No Answer or Busy
Used to assign a speed dial number when a
dial tone times-out and the target extension
does not answer or is busy.
Speed Dial bin number 0 ~ 1999
1999
25-16-01
DID/DISA Talkie Base Setup – Single Digit
Timer
Assign a timer, per single digit table, required to
expire before the allocated single digit entry is
applied.
0 ~ 64800
(0 = No Setting)
0
25-16-02
DID/DISA Talkie Base Setup – DTMF Detect
1 = On setting detects DTMF signal during
sending VRS message for DID/DISA call.
0 = Off setting does not detect DTMF signal
during sending VRS message for DID/DISA
call.
0 = Off
1 = On
1
31-02-01
Internal Paging Group Assignment –
Internal Paging Group Number
Assign extensions to Internal Paging Groups
(i.e., Page Zones).
0 ~ 64
(0 = No Setting)
0 for IP Station
1 for TDM
Station
31-02-02
Internal Paging Group Assignment –
Internal All Call Paging Receiving
Allow/Prevent All Call Internal Paging for each
extension. If allowed, extension can place and
receive All Call Internal Paging
announcements. If prevented, extensions can
make only (not receive) All Call Internal Paging
announcements. If combined, Paging zones
should be restricted as well. Change the
internal page zone group in Program 31-07-01
to 0.
0 = Off
1 = On
0