1401
❍
Program 20-13-54 is set to Enable.
❍
Program 20-13-06 is set to Automatically
1.
From ext 100 call IP DECT 200 (1st call).
2.
Answer on IP DECT 200 and talk with ext 100.
3.
From ext 101 Call IP DECT (2nd call).
4.
IP DECT receives off-hook signal.
5.
Press the * button on the IP DECT. Hold the 1st call and answer the 2nd call.
6.
Talk with ext 101.
7.
Use on-hook on ext 101. A busy tone is heard on the IP DECT.
8.
Press the * button on the IP DECT and retrieve the 1st call (On hold).
9.
Talk with ext 100.
Caller ID Display After a Call Transfer
To make screened transfer to IP DECT of trunk call:
Transferee : Caller ID:297XXXYYY
Transferrer : Multi line, Ext 100
Transfer target : IP DECT, Ext 200
1.
Place a call to ext 100 from outside party 297XXXYYY.
2.
Answer incoming call at ext 100 and press the Transfer button.
3.
Dial 200 to call an IP DECT.
4.
Announce the call and press the Transfer button or hang up ext 100.
5.
Calling party number “297XXXYYY” is displayed on the IP DECT.
To make unscreened transfer to IP DECT of trunk call:
Transferee : Caller ID:297XXXYYY
Transferrer : Multi line, Ext 100
Transfer target : IP DECT, Ext 200
1.
Place a call to ext 100 from outside party 297XXXYYY.
2.
Answer incoming call at ext 100 and press the Transfer button.
3.
Dial 200 to call an IP DECT.
4.
Press the Transfer button or hang up ext 100.
5.
The IP DECT rings and calling party number “297XXXYYY” is displayed on the IP
DECT.
To Next Page
Loading...
