NEC Univerge SV9100 - Page 158

158
Program
Number
Program Name/Description
Input Data
Default
11-11-45
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward All
(Split)
Assign the Call Forward All Split Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-46
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward Busy
(Split)
Assign the Call Forward Busy Split Service
Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-47
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward No
Answer (Split)
Assign the Call Forward No Answer Split
Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-48
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward Busy/
No Answer (Split)
Assign the Call Forward Busy No Answer Split
Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-49
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward Both
Ring (Split)
Assign the Call Forward Both Ring Split Service
Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-52
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward All
Destination (No Split)
Assign the Call Forward All for any Extension
Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
890
11-11-53
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward Busy
Destination (No Split)
Assign the Call Forward Busy for any Extension
Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
891
11-11-54
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward No
Answer Destination (No Split)
Assign the Call Forward No Answer for any
Extension Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
892
11-11-55
Service Code Setup (for Setup/Entry
Operation) – Set/Cancel Call Forward Busy/
No Answer Destination (No Split)
Assign the Call Forward Busy No Answer for
any Extension Service Code.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
893
14-01-13
Basic Trunk Data Setup – Trunk-to-Trunk
Transfer
Enable/Disable loop supervision for the trunk.
0 = Disable (No)
1 = Enable (Yes)
1