NEC Univerge SV9100 - Page 160

160
Program
Number
Program Name/Description
Input Data
Default
21-03-01
Trunk Group Routing for Trunks
Used to set the Trunk Route Table for
Automatic External Call Forward.
Day Night/Mode: 1 ~ 8
0 ~ 100
(0 = No setting)
1
24-02-07
System Options for Transfer – Trunk-to-
Trunk Transfer Release Warning Tone
Timer starts when a trunk begins talking with
another trunk (for example: Trunk-to-Trunk
Transfer, outgoing from trunk, Tandem
Trunking). When this time expires, a warning
tone is heard.
0 ~ 64800 seconds
1800
24-09-01
Call Forward Split Settings – Call
Forwarding Type
Assign Call Forwarding Type and destination
numbers for each extension/virtual extension.
0 = No Call Forwarding
1 = Call Forward Both
2 = Call Forward No Answer
3 = Call Forward All
4 = Call Forward Busy No
Answer
5 = Call Forward Busy
0
24-09-02
Call Forward Split Settings – CO Call
Forwarding Destination for Both Ring, All
Call, No Answer
Assign CO Call Forwarding destination
numbers for both ring, all call and no answer.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-03
Call Forward Split Settings – Intercom Call
Forwarding Destination for both ring, All
Call, No Answer
Assign Intercom Call Forwarding destination
numbers for both ring, all call and no answer.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-04
Call Forward Split Settings – CO Call
Forwarding Busy Destination
Assign CO Call Forwarding busy destination
numbers.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-05
Call Forward Split Settings – Intercom Call
Forwarding Busy Destination
Assign Intercom Call Forwarding busy
destination numbers.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting