EasyManua.ls Logo

NEC Univerge SV9100 - Page 215

NEC Univerge SV9100
1402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
215
Program
Number
Program Name/Description
Input Data
Default
20-11-28
Class of Service Options (Hold/Transfer
Service) Both Ring Enhancement
0 = Normal (default) rings on other extension
when the other paired extension is busy (not
idle).
1 = Enhanced does not ring other extension
when the other paired extension is busy (not
idle).
0 = Normal
1 = Enhanced
COS 1 ~ 15 = 0
20-11-30
Class of Service Options (Hold/Transfer
Service) Disable Call FWD Indication on
LCD
When set to On (1), Call FWD setting is not
shown on the terminal LCD.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-12-02
Class of Service Options (Charging Cost
Service) Advice of Charge
ISDN-AOC
Turn Off or On a DISA or tie trunk caller ability
to dial 9 for Trunk Group Routing or Automatic
Route Selection (ARS).
0 = Off
1 = On
COS 1 ~ 15 = 0
20-12-03
Class of Service Options (Charging Cost
Service) Cost Display (TTU)
ISDN billing information.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-01
Class of Service Options (Supplementary
Service) Long Conversation Alarm
Turn Off or On the Warning Tone for Long
Conversation (not for single line telephones).
0 = Off
1 = On
COS 1 ~ 15 = 0
20-13-02
Class of Service Options (Supplementary
Service) Long Conversation Cutoff
(Incoming)
Turn Off or On an extension user ability to use
Long Conversation Cutoff for incoming calls.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-13-03
Class of Service Options (Supplementary
Service) Long Conversation Cutoff
(Outgoing)
Turn Off or On an extension user ability to use
Long Conversation Cutoff for outgoing calls.
0 = Off
1 = On
COS 1 ~ 15 =0
20-13-04
Class of Service Options (Supplementary
Service) Call Forward/DND Override
(Bypass Call)
Turn Off or On the ability to use Call
Forwarding/DND Override.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-05
Class of Service Options (Supplementary
Service) Intercom Off-Hook Signaling
Turn On or Off the ability of an extension to
send Off-Hook Signals.
This setting functions with Programs 20-09-07
and 20-13-06 disabled.
0 = Off
1 = On
COS 1 ~ 15 = 1

Table of Contents

Other manuals for NEC Univerge SV9100

Related product manuals