NEC Univerge SV9100 - Page 22

22
Program
Number
Program Name/Description
Input Data
Default
35-05-02
Account Code Setup – Forced Account
Code Toll Call Setup
Enable Account Codes for all calls or just toll
calls (for mode 2 or 3 in Program 35-05-01).
0 = Account Codes for toll and
local calls (All)
1 = Account Codes just for toll
calls (STD)
0
35-05-03
Account Code Setup – Account Codes for
Incoming Calls
For each Class of Service (1 ~ 15), enter 1 in
this option to Enable Account Codes for
incoming calls. Enter 0 to Disable Account
Codes for incoming calls. If disabled, any codes
you enter dial out on the connected trunk.
0 = Account Codes for incoming
calls disabled (No)
1 = Account codes for incoming
calls enabled (Yes)
0
35-05-04
Account Code Setup – Hiding Account
Codes
For each Class of Service (1 ~ 15), enter 1 to
have the system hide Account Codes on an
extension display as they are entered. Enter 0
to have the Account Codes displayed.
0 = Account Codes not
displayed
1 = Account Codes displayed
0
35-06-01
Verified Account Code Table – Verified
Account Code
Enter data in the Verified Account Code Table.
You can enter up to 2000 codes from 3 ~ 16
digits in length. For a wild card @, press the LK
1.
This Program will accept a 1 or 2 digit code but
requires a valid input of 3 ~ 16 digits to function.
Maximum of 16 digits.
1 ~ 9, 0, #, @ (@ = Wild card)
No Setting
40-10-01
Voice Announcement Service Option – VRS
Fixed Message
Enable (1) or Disable (0) the system ability to
play the fixed VRS messages (such as You
have a message).
0 = Not Used
1 = Used
0
Operation
To enter an Account Code anytime while on a trunk call:
The outside caller cannot hear the Account Code digits you enter. Use this procedure if your system has
Optional Account Codes enabled. You may also use this procedure for incoming calls. This procedure is
not available for single line telephones.
1. Dial * .
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).
2. Dial your Account Code (1~16 digits, using 0~9 and #).
 If Account Codes are hidden, each digit you dial shows * on the telephone display.
3. Dial * .
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).