NEC Univerge SV9100 - Page 26

26
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-11-12
Service Code Setup (for Setup/Entry
Operation) – Alarm Clock
Customize the alarm clock used for registration
and setup.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
827
20-01-06
System Options – Alarm Duration
Set the duration of the Alarm signal.
0 ~ 64800 seconds
30
Operation
To set the alarm:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 827.
3. Dial alarm type (1 or 2).
 Alarm 1 sounds only once. Alarm 2 sounds each day at the preset time.
4. Dial the alarm time (24-hour clock).
 For example, for 1:15 PM dial 1315.
A confirmation tone is heard if the alarm has been set. If the alarm was not set, an error tone is heard
instead.
5. At the multiline terminal, press Speaker to hang up.
- OR -
At the single line telephone, hang up.
To silence an alarm:
1. At multiline terminal, press Exit.
- OR -
At the single line telephone, lift the handset.
 The single line set user hears Music on Hold when the handset is lifted.
To check the programmed alarm time at a multiline terminal:
1. Press Help.
2. Dial 827.
3. Dial alarm type (1 or 2).
 The programmed time displays.
4. Press Exit.