NEC Univerge SV9100 - Page 383

383
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-09-01
DTMF and Dial Tone Circuit Setup
Reserve at least one circuit for DTMF reception
(entry 0 or 2).
Use the following as a guide when allocating
DTMF receivers:
In light traffic sites, allocate one DTMF
receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF
receiver for every five devices that use
them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
11-01-01
System Numbering
Define the system numbering plan.
11-09-02
Trunk Access Code – 2nd Trunk Route
Access Code
Assign the Service Code set up in Program
11-01 for 2nd (Alternate) Trunk Route Access.
Dial (maximum of four digits)
No Setting
14-01-02
Basic Trunk Data Setup – Transmit Level
Customize the transmit and receive levels of
the CODEC Gain Types for each trunk.
Trunks 1 ~ 400
1 ~ 57
(-15.5 ~ +12.5dB in 0.5dB
intervals)
32 (0dB)