NEC Univerge SV9100 - Page 485

485
Program
Number
Program Name/Description
Input Data
Default
11-08-01
ACI Group Pilot Number
Assign pilot numbers to ACI groups. When a
user dials the pilot number, they reach an
available ACI software port within the group.
Dial (maximum of eight digits).
ACI Groups 1 ~ 16
No Setting
11-09-01
Trunk Access Code
If required, change the single-digit Trunk
Access Code (normally 9). If you change this
code, you must also review the settings in
Program 11-01-01 for the new code selected.
Dial (maximum of four digits)
9
11-09-02
Trunk Access Code – 2nd Trunk Route
Access Code
Assign the Service Code set up in Program
11-01-01 for Alternate Trunk Route Access.
Dial (maximum of four digits)
No Setting
11-10-01
Service Code Setup (for System
Administrator) – Night Mode Switching
Customize the night mode switching Service
Codes for the System Administrator.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
818
11-10-02
Service Code Setup (for System
Administrator) – Music On Hold Tone
Customize the night mode switching Service
Codes for the System Administrator.
MLT, SLT
0 ~ 9, *, # Maximum of eight digits
881
11-10-03
Service Code Setup (for System
Administrator) – Setting the System Time
Customize the system time Service Codes for
the System Administrator.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
828
11-10-04
Service Code Setup (for System
Administrator) – Storing Common Speed
Dialing Numbers
Store common speed dialing Service Codes for
the System Administrator.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
853
11-10-05
Service Code Setup (for System
Administrator) – Storing Group Speed
Dialing Numbers
Store group speed dialing numbers for the
System Administrator.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
854
11-10-06
Service Code Setup (for System
Administrator) – Setting the Automatic
Transfer for Each Trunk Line
Set the service code for setting automatic
transfer for each trunk line.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
833
11-10-07
Service Code Setup (for System
Administrator) – Canceling the Automatic
Transfer for Each Trunk Line
Set the service code for canceling automatic
transfer for each trunk line.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
834
11-10-08
Service Code Setup (for System
Administrator) – Setting the Destination for
Automatic Trunk Transfer
Set the service code for setting the destination
for automatic trunk transfer.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
835