NEC Univerge SV9100 - Page 52

52
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-12-32
Service Code Setup (for Service Access) –
Answer for Park Hold
Assign a key on the multiline terminal or single
line telephone for park hold.
MLT, SLT
Maximum of eight digits
0 ~ 9,
*
, #
*6
15-02-06
Multiline Telephone Basic Data Setup – Hold
Key Operating Mode
Set the function of the Multiline Hold key. The
Hold key can activate normal Hold or Exclusive
Hold.
0 = Normal (Common)
1 = Exclusive Hold
0
15-07-01
Programmable Function Keys
Assign a park group to multiline terminal line
key.
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-09-01
Class of Service Options (Incoming Call
Service) – Second Call for DID/DISA/DIL/
E&M Override
Turn Off or On the extension ability to receive a
second call from a DID, DISA, DIL, or tie line
caller.
With this option set to 1, the destination
extension must be busy for a second DNIS caller to
ring through. If the destination extension does not
have a trunk or CAP key available for the second
call and a previous call is ringing the extension but
has not yet been answered, the second caller hears
busy regardless of this program setting.
0 = Off
1 = On
COS 1 ~15 = 1
Operation
To answer a call on a different line key or CAP key with a call in progress:
1. Receive a CO/PBX, DID/DISA/DIL/E&M incoming ring.
 Answer flashes.
2. Press Answer, and answer the new call.
 The Answer LED goes out. The original call is put on hold.
3. If additional calls are received, press Answer to place the current call on hold and connect to the
next call as long as Call Appearance Keys and or CO line keys are available.